Instructions:

1. Place the washer over the threads of the microphone stand. This will supports the Walker Wire.

2. Next, loop the Walker Wire component(s) over the thread.

3. Next, thread on the lock nut.
4. Position the WalkerWire about 11 O’clock and tighten toghether to a 12 o’clock position.

Place the neck of the instrument into the back of the jaws of the hanger below the nut/headstock, lower headstock down to rest on the arm/cheek of the WalkerWire making sure the front of the headstock is behind the tooth, so as not to twist out.